Stick-on Four Button USB MIDI Controller


Sometimes your gear really needs a few MIDI control buttons strategically located. Now you can stick them on.

https://github.com/gdsports/buttons4

Comments

Post a Comment

Popular posts from this blog

Defective Arduino USB Host Shield Boards

Image
UPDATE: The red wire is not needed. There are solder pads to the right of the reset button. Bridge the 5V pads to select 5V for VBUS PWR. In total, three blobs of solder are needed to make the shield work for 5V Arduinos. I received two new generic Arduino compatible USB host shields today. Both are defective. But they work after some troubleshooting. 1. After loading the USB_desc sketch, the debug message "OSC did not start." appears on the serial console. This means the USB host library cannot find the USB host hardware. I compared a defective board with a working board. One big difference is the 3.3V pads and 5V pads are not bridged on the defective board. This means the shield is not receiving power from the Uno! After bridging the pads, the board powers up. The error message "OSC did not start" does not appear. This means the USB host library found the USB host hardware. In the photo, the green boxes should contain one big solder blob. If there are...
Read more

USB Host Library for SAMD

Image
The USB Host Library for SAMD  is based on the USB Host Shield Library 2.0 with modifications to work on Arduino and Arduino compatible SAMD boards. Some drivers (ftdi, pl2303, cdcacm, HID, MIDI, Xbox controller, and Playstation controller) have been tested and some not at all (ADK and Bluetooth). The Arduino Zero, M0, and MKR Zero boards are known to work. A few Adafruit M0 (Trinket M0 and Feather M0 Express) and Metro M4 boards are also known to work. The library uses the built-in USB OTG hardware also known as the native USB port. The MAX3421E controller is not supported. The Arduino Due native USB port is not supported. USB Host Library for SAMD
Read more

WeMos D1 R2 ESP8266 with USB Host Shield

Image
WiFi-enable a wide variety of USB devices using an ESP8266 and a USB host shield. For example, add a WiFi interface to a USB barcode reader or a USB RFID keyfob reader. The USB Host for Arduino driver  project has added support for ESP8266 so here are some of my experiments. For more details, see the demos on github.com. A modified USB Host Shield is plugged into a WeMos D1 R2 ESP8266 board. A USB host mini board fits on top of an Adafruit ESP8266 Feather. This configuration turns a $16 USB barcode scanner into a battery powered WiFi barcode scanner.
Read more